Units can have bars applied to either one or both sides of the window as required and the bars will flex with the unit – so that if "toe and heeling" is required this will not impact on the effectiveness of the bars. If, however, reglazing is required, then the bars can be easily removed and reapplied on site.

U-clip onto IG unit

Temp tape down U-Clip onto IG unit (optional)

Ready to glaze IG unit

Set IG unit into Sash

Glaze unit as per MFG instructions

Measure and cut WINtek grid

Measure and cut cross grids and place on Cruciform clip

Finished Unit Check

Finished Unit Check

Finished Unit Check

• The components comprise of edge clips, center clips and the WINtek Bars
• Place the edge clips in the required positions around the sealed glazing units
• Glaze window as per manufacturing glazing instructions. Ensure that clips have retained their position prior to final beading
• Using an alcohol wipe ensure that all surfaces are clean, dry and free of grease
• Accurately align the center clip to the edge clips, place a 1 5/8" length of double sided tape to the underside of the center clip and fix in place
• For spans over 11" inches between clips an intermediate bridging piece should be used to increase rigidity
• Precisely cut and mill/miter the full length bar. This should always be the shortest span for maximum rigidity
• Cut and mill/miter the remaining bars and complete installation